5. Authenticator: Setting up the Authenticator (Access
Point)
During the authentication process, the Authenticator just relays all
messages between the Supplicant and the Authentication Server
(RADIUS). EAPOL is used between the Supplicant and the Authenticator;
and, between the Authenticator and the Authentication Server, UDP is
used.
5.1. Access Point
Many access point have support for 802.1X (and RADIUS)
authentication. It must first be configured to use 802.1X
authentication.
 |
Configuring and setting up 802.1X on the AP may differ
between vendors. Listed below are the required settings to
make a Cisco AP350 work. Other settings to TIKP, CCMP etc. may also
be configured.
|
The AP must set the ESSID to "testnet" and must
activate:
802.1X-2001: Make sure the 802.1X Protocol
version is set to "802.1X-2001". Some older Access
Points support only the draft version of the 802.1X standard (and
may therefore not work).
RADIUS Server: the name/IP address of the
RADIUS server and the shared secret between the RADIUS server and
the Access Point (which in this document is "SharedSecret99"). See
figure AP350.
EAP Authentication: The RADIUS server should be
used for EAP authentication.
Full Encryption to allow only encrypted
traffic. Note that 802.1X may be used without using encryption,
which is nice for test purposes.
Open Authentication to make the Supplicant
associate with the Access Point before encryption keys are
available. Once the association is done, the Supplicant may start EAP
authentication.
Require EAP for the "Open
Authentication". That will ensure that only authenticated
users are allowed into the network.
5.2. Linux Authenticator
An ordinary Linux node can be set up to function as a wireless Access
Point and Authenticator. How to set up and use Linux as an AP is
beyond the scope of this document. Simon Anderson's Linux
Wireless Access Point HOWTO may be of guidance.
Take our 
